User's Manuals
  Brands Categories News Search About Translate by Google
 
   

Table of Content

Introduction
Features And Functions
Installing Batteries
Programming Device Controls
Searching For Your Code
Checking The Codes
Programming A Master Power Macro
Re-assigning Device Keys
Using Channel Scan
Programming Favorite Channel Scan
Changing Volume Lock
Clearing Custom Programming
Restoring Factory Default Settings
Troubleshooting
Instructions To The User
Lifetime Warranty

 

Universal Remote Control (URC-3220)

Changing Volume Lock

The One For All 3 Device Universal Remote Control is set at the factory for independent volume control of each selected device.However, you may change the Volume Lock setting to Global Volume Lock so that a device’s volume will be locked to one mode (e.g., to control TV volume in all other modes). After that, if desired, you can perform Individual Volume Unlock on a selected device to set its volume control for independent operation.

Locking Volume Control To One Mode
(Global Volume Lock)

  1. Press and hold SET until the LED (red light) blinks twice, then release SET.

  2. Enter 9 - 9 - 3 and then press any mode key once (e.g., TV). The LED will blink twice.

  3. Now, when you press VOL +, VOL -, or MUTE, the volume of the selected device (e.g., TV) will be controlled, regardless of the mode you have selected.

Unlocking Volume Control For A Single Device
(Individual Volume Unlock)

  1. After performing Global Volume Lock (above),press a desired mode key where you want volume to be unlocked (e.g., DVD/VCR) and controlled within its own mode.

  2. Press and and hold SET until the LED (red light) blinks twice, then release SET.

  3. Enter 9 - 9 - 3 and then press VOL - once.The LED will blink four times.

  4. If desired, repeat steps 1 through 3 (of this section) for each device that you want volume to be unlocked.

  5. After selecting a device that has volume unlocked (e.g., DVD/VCR), pressing VOL +, VOL -, or MUTE will control the device’s volume only in its own mode.

Unlocking All Volume Control
(Restoring Default Setting)

NOTE: Performing these instructions will restore independent volume control for all programmed devices (e.g., TV volume control in TV mode,VCR volume in DVD/VCR mode, etc.).
  1. On the remote control, press and hold SET until the LED (red light) blinks twice, then release SET.

  2. Enter 9 - 9 - 3 and then press VOL + once.The LED will blink four times.

  3. Volume will again be independently controlled according to its default states for all programmed devices.

 
   
  Compiled by Free Tech Secrets ;), 2008 greatis just4fun network