Universal Remote Control (URC-3220)
Troubleshooting
PROBLEM: LED (red light) does not blink when you press a key.
SOLUTION: Replace batteries with two new AAA alkaline batteries.
PROBLEM: LED blinks when you press a key, but home entertainment
device does not respond.
SOLUTION: Make sure the remote control is aimed at your home
entertainment device and is not farther than 15 feet
away.
PROBLEM: The unit does not control home entertainment devices
or commands are not working properly.
SOLUTION: Try all listed codes for the device brands being set up.
Make sure they can be operated with an infrared remote
control.
PROBLEM: Changing channels does not work.
SOLUTION: If original remote required pressing ENTER or SELECT to
change channels,press ENTER or SELECT on this remote after
entering the channel number.
PROBLEM: Tried Searching For Your Code method and still could not
find a working code.
SOLUTION: Clear the device key as follows: Press and hold SET until
the LED (red light) blinks twice, then release.Next enter
9 - 9 - 2.Then press the device key to be cleared twice.
Now repeat the Searching For Your Code method on page
9.
PROBLEM: CH + and CH - do not work for your RCA TV.
SOLUTION: Due to RCA design (1983-1987), only the original
remote control will operate these functions.
PROBLEM: No remote control of volume.
SOLUTION: See Changing Volume Lock on page 12 to lock/unlock
volume.
For assistance, please contact us in any of the following ways:
| 