Table of Content

Introduction
Features And Functions
Installing Batteries
Programming Device Controls
Searching For Your Code
Checking The Codes
Programming A Master Power Macro
Re-assigning Device Keys
Using Channel Scan
Programming Favorite Channel Scan
Changing Volume Lock
Clearing Custom Programming
Restoring Factory Default Settings
Troubleshooting
Instructions To The User
Lifetime Warranty

Universal Remote Control (URC-3220)

Checking The Codes

If you have set up the remote control using the Searching For Your Code pro-cedure as above, you may need to find out which four-digit code is operating your equipment. For example, to find out which code is operating your TV:

1. On the remote control, press TV once.

2. Press and hold SET until the LED (red light) blinks twice, then release SET.

3. Enter 9 - 9- 0. The LED will blink twice.

4. To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED blinks (e.g., three blinks = 3) and write down the number in the leftmost box in the TV code boxes on page 8.

   NOTE: If a code digit is “0”, the LED will not blink

5. Repeat step 4 three more times for remaining digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit. Write down the code digits in the remaining TV code boxes on page 8.

6. To check for codes of other devices, repeat steps 1 through 5, but substitute the appropriate device key for each device you are checking. Write down the device’s code digits in the appropriate code boxes on page 8.