|
|
| |
Universal Remote Control (URC-3220)
Programming A Master Power Macro
In its default state, the POWER key on the One For All 3 Device Universal Remote Control will individually power your home entertainment devices on or off. However, you can also program a Master Power Macro onto the POWER key that will sequentially turn on or off all the devices with a single key press.
Programming The Power Key For The Master Power Macro
- Press and hold SET until the LED (red light) blinks twice, then release SET.
- Enter 9 - 9 - 5. The LED will blink twice. Then press POWER once.
- For the first device you want in the power-on sequence, press its device key (e.g., CBL/SAT) once.
- Repeat step 3 up to two more times to add desired devices to the power-on sequence (e.g., DVD/VCR and TV).
- To save the settings and exit the program, press and hold SET until the LED blinks twice, then release SET.
Operating The Master Power Macro
- After programming, point the remote control at the devices and press POWER for at least 2 seconds to sequentially turn on (or off) your devices.
NOTE: When POWER is pressed for less than 2 seconds, a power command will only be sent to the currently-selected device. This allows you to still individually power devices on or off
- Devices will turn on (or off) according to your programmed sequence.
NOTE: The currently-selected device will always turn on or off first, followed by the remaining programmed sequence. After the master power sequence has been completed, the remote control will be set to control the first powered-on device.
NOTE: If one or more devices does not have a POWER key, the power offon sequence may be slightly delayed when the remote control signals the device(s). This action is normal
Clearing The Master Power Macro
- Press and hold SET until the LED (red light) blinks twice, then release SET.
- Enter 9 - 9 - 5. The LED will blink twice. Then press POWER once.
- Press and hold SET until the LED blinks twice, then release SET. The Master Power Macro is now cleared.
| |
|
